MSDS Rubber Base
Rubber Base Material Safety Data Sheet
Chemical product and company identification
|
Product name: Rubber base |
Manufacturer: WCD Nail Dips Ltd |
|
Product No: WCRB |
Address: 44692 Lancaster Drive, Chilliwack BC V2R 3B8 |
|
Product type: Ultraviolet |
Mobile:778-233-4170 |
|
Product Use: Nail Gel |
Email: support@westcoastdips.ca |
2. Ingredients
|
Chemical Components |
CAS NO |
INCI NO |
concentrationWT% |
|
Acrylates Copolymer |
25035-69-2 |
Acrylates Copolymer |
30-55 |
|
Trimethylolpropane Triacrylate |
15625-89-5 |
Trimethylolpropane Triacrylate |
15-30 |
|
Ethyl Methacrylate |
97-63-2 |
Ethyl Methacrylate |
10-30 |
|
Ethyl Acetate |
141-78-6 |
Ethyl Acetate |
5-10 |
|
Dimethicone |
9016-00-6 |
Dimethicone |
2-5 |
|
Microcrystalline Wax |
63231-60-7 |
Microcrystalline Wax |
1-5 |
|
Aluminum Powder 7429 |
7429-90-5 |
CI 77000 |
0-5 |
|
Mica |
12001-26-2 |
Mica |
0-2 |
|
Iron Oxide |
12227-89-3 |
CI 77499 |
0-2 |
|
Ferric Ferrocyanide |
14038-43-8 |
CI 77510 |
0-2 |
|
Yellow 5 |
12225-21-7 |
CI 19140 |
0-2 |
|
Bismuth Oxychloride |
7787-59-9 |
CI 77163 |
0-2 |
|
BLACK 2 |
1333-86-4 |
CI 77266 |
0-2 |
|
Iron Oxide |
1345-25-1 |
CI 77491 |
0-2 |
|
Titanium Dioxide 13463-67-7 |
|
CI 77891 |
0-2 |
3.Hazards identification
Emergency Overview
Physical state: Liquid HEALTH: 1*
Color: transparent FLAMMABILITY: 2 Odor: light PHYSICAL HAZARD: 1 Personal Protection: See Section 8
WARNING: HARMFUL IF SWALLOWED, ABSORBED THROUGH SKIN OR INHALED. DO NOT SPRAY. DO NOT HEAT.MAY CAUSE ALLERGIC SKIN REACTION.CAUSES EYE, SKIN AND RESPIRATORY TRACT IRRITATION
Relevant routes of exposure: Skin, Inhalation, Eyes
Potential Health Effects
Skin contact: Contact skin will cause irritation.
Eye contact: Contact with eyes will cause irritation.
4. First aid measures
Inhalation: Remove to fresh air. If symptoms develop and persist, get medical attention.
Skin contact: Immediately flush skin with plenty of water (using soap, if available). Remove contaminated clothing and shoes. Wash clothing before reuse. Get immediate medical attention if symptoms occur.
Eye contact: Immediately flush eyes with plenty of water for at least 15 minutes. Get immediate medical attention.
Ingestion: Do not induce vomiting. Keep the individual calm. Get medical attention immediately
5. Fire-fighting measures
Flash point:105°C
Autoignition temperature: Not available
Flammable/Explosive limits-lower %: Not available
Flammable/Explosive limits-upper %: Not available
Extinguishing media: Foam, dry chemical or carbon dioxide.
Special fire fighting procedures: Wear self-contained breathing apparatus and full protective clothing, such as turn-out gear.
Unusual fire or explosion hazards: Uncontrolled polymerization may occur at high temperatures resulting explosions or rupture of storage containers.
Hazardous combustion products: Oxides of carbon. Oxides of nitrogen. Irritating organic vapours. Toxic Fumes.
6. Accidental release measures
Environmental precautions: Remove sources of ignition. Prevent product from entering drains or open waters.
Clean-up methods: Refer to Section 8 "Exposure Controls / Personal Protection" prior to cleanup. Soak up with inert absorbent. Store in a partly filled, closed container until disposal.
7. Handling and storage
Handling: Prevent contact with eyes, skin and clothing. Do not breathe vapor and mist. Wash thoroughly after handling. DO NOT heat or spray. Use only with adequate ventilation. Refer to Section 8. Use only in area provided with appropriate exhaust ventilation.
Storage: For safe storage, store at or below 26°C (80°F). Keep in a cool, well ventilated area away from heat, sparks and open flame. Keep container tightly closed until ready for use. Incompatible products: Refer to Section 10.
8. Exposure controls/personal protection
Engineering controls: Local exhaust ventilation is recommended when general ventilation is not sufficient control airborne contamination below occupational exposure limits.
Respiratory protection: Use COSHA approved respirator if there is potential to exceed exposure limit(s).If this material is handled at elevated temperatures or under mist forming conditions, without engineering controls, a COSHA approved respirator must be used.
Skin protection: Use impermeable gloves and protective clothing as necessary to prevent skin contact. Neoprene gloves.
Eye/face protection: Safety goggles or safety glasses with side shields. In a splash hazard environment, chemical goggles should be used in combination with a full face shield.
9. Physical and chemical properties
Physical state: Liquid Color: transparent
Odour: light Vapour pressure: Not available pH: Not applicable Boiling point/range: Greater than 93°C(200°F)Melting point/range: Not available Specific gravity: 1.10 Vapour density: Not available Evaporation rate: Not available Solubility in water: Slight Partition coefficient (n-octanol/water): Not available VOC content: Total volatiles 0.80 %
10.Stability and reactivity
Stability: Stable under normal conditions of storage and use.
Hazardous polymerization: May occur.
Hazardous decomposition products: Oxides of carbon. Oxides of nitrogen. Dimethylamine. Irritating Organic vapours.
Incompatibility: Strong acids. Strong oxidizing agents. Bases.
Conditions to avoid: Heat, flames, sparks and other sources of ignition. Do not heat above 26°C(80°C). 11.Toxicological information
Carcinogen Status
|
Hazardous components |
NTP Carcinogen |
IARC |
CarcinogenCOSHACarcinogen |
|
Acrylates Copolymer |
NO |
NO |
NO |
|
Trimethylolpropane Triacrylate |
NO |
NO |
NO |
|
Ethyl Methacrylate |
NO |
NO |
NO |
|
Ethyl Acetate |
NO |
NO |
NO |
|
Dimethicone |
NO |
NO |
NO |
|
Microcrystalline Wax |
NO |
NO |
NO |
|
Aluminum Powder |
NO |
NO |
NO |
|
Mica |
NO |
NO |
NO |
|
Iron Oxide |
NO |
NO |
NO |
|
Ferric Ferrocyanide |
NO |
NO |
NO |
|
Yellow 5 |
NO |
NO |
NO |
|
Bismuth Oxychloride |
NO |
NO |
NO |
|
BLACK 2 |
NO |
NO |
NO |
|
Iron Oxide |
NO |
NO |
NO |
|
Titanium Dioxide |
NO |
NO |
NO |
Literature Referenced Target Organ & Other Health Effects
|
Hazardous components |
Health Effects/Target Organs |
|
Acrylates Copolymer |
No Records |
|
Trimethylolpropane Triacrylate |
No Records |
|
Ethyl Methacrylate |
No Records |
|
Ethyl Acetate |
No Records |
|
Dimethicone |
No Records |
|
Microcrystalline Wax |
No Records |
|
Aluminum Powder |
No Records |
|
Mica |
No Records |
|
Iron Oxide |
No Records |
|
Ferric Ferrocyanide |
No Records |
|
Yellow 5 |
No Records |
|
Bismuth Oxychloride |
No Records |
|
BLACK 2 |
No Records |
|
Iron Oxide |
No Records |
|
Titanium Dioxide |
No Records |
12.Ecological information
Ecological information: Not available
13.Disposal considerations
Information provided is for unused product only.
Recommended method of disposal: Dispose of according to province and local governmental regulations.
ECE hazardous waste number: Not a RCRA hazardous waste.
14.Transport information
The shipping classifications in this section are for non-bulk packaging only (unless otherwise specified).Shipping classification may be different for bulk packaging.
Department of Transportation Ground :
Proper shipping name: Unrestricted
Hazard class or division: None
Identification number: None
Packing group: None
International Air Transportation (ICAO/IATA):
Proper shipping name: Unrestricted
Hazard class or division: None
Identification number: None
Packing group: None
Water Transportation (IMO/IMDG):
Proper shipping name: Unrestricted
Hazard class or division: None
Identification number: None
Packing group: None
Marine pollutant: None
15.Regulatory information
All components are listed or are exempt from listing on the Toxic Substances Control Act Inventory.
DISCLAIMER: The data contained herein are furnished for information only and are believed to be reliable. However, WCD Nail Dips Ltd does not assume responsibility for any results obtained by persons over whose methods WCD Nail Dips Ltd has no control. It is the user's responsibility to determine the suitability of WCD’s products or any production methods mentioned herein for a particular
purpose, and to adopt such precautions as may be advisable for the protection of property and persons against any hazards that may be involved in the handling and use of any of WCD Nail Dips Ltd’s products. In light of the foregoing, WCD Nail Dips Ltd specifically disclaims all warranties, express or implied, including warranties of merchantability and fitness for a particular purpose, arising from sale or use of WCD Nail Dips Ltd products. WCD Nail Dips Ltd further disclaims any liability for consequential or incidental damages of any kind, including lost profits.